JLCooper ES-450SP - Manual (Page 6)

6
Configuration
Before using the ES-450SP, we recommend setting it up for the
various ways you may need to use it in.
Step Mode
This setting is used to set how the ES-450SP performs the
Frame+1 and Frame-1 operations. This determines how the ES-
450SP behaves at whole second boundaries. This is toggled by
pressing SHIFT+STOP. The two options are:
• Cue Up Step Mode (Default)
This configures the ES-450SP to send a Cue Up with Data
command when the Frame+1 (or Frame-1) button is
pressed. This essentially commands the machine to locate
to the next frame (or previous frame).
• SloMo Step Mode
This configures the ES-450SP to send a Shuttle command
when the Frame+1 (or Frame-1) button is pressed. This
essentially commands the machine to shuttle forward (or
reverse) until the next frame (or previous frame) is
encountered.
Frame Rate
This setting is used to set the frame rate used in Frame+1 and
Frame-1 calculations. This is done by pressing SHIFT + EJECT.
This will switch between the following frame rates:
• 24 (Film)
• 25 (PAL)
• 30 (NTSC)