JLCooper ES-450SP - Manual (Page 10)

10
PLAY, FAST FORWARD and REWIND. Additionally, there is
an EJECT button in the upper left hand corner of the front panel.
Typically, pressing the STOP button places the machine into Still
or Pause mode so the operator can view the image on tape.
Pressing FAST FORWARD and REWIND place the machine into
Shuttle Forward and Shuttle Reverse respectively. These functions
may be implemented differently in your machine or editing
software.
Track Arming
Above the Transport Controls are the Track Arming buttons, which
select tracks to be overwritten when the machine is placed in
Record. Pressing the ASM button will place the machine in to
Assemble mode where the video and audio tracks are written. To
insert new material over existing material, the Insert mode is used.
To initiate Insert mode, press the INS button and any tracks you
wish to record.
LEDs above the Track Arming buttons indicate the tracks that are
armed or being recorded on.
Record is initiated by pressing REC/SHIFT and F-PLAY.
Editing Controls
Located around the JOG/SHUTTLE WHEEL are the Editing
Controls. At the top center just above the JOG/SHUTTLE
WHEEL is the SHUTTLE SELECT button. The SHUTTLE
SELECT button allows the machine to return to a shuttle operation
after it has been interrupted by a Stop, Frame+1, Frame-1 or Goto
command. The direction arrows indicate the direction of the
pending shuttle. In Jog mode, this button has no effect.
On either side of the SHUTTLE SELECT button are the
FRAME+1 and FRAME-1 buttons. Pressing either of these
buttons will move or bump the tape forward or backwards one
frame. This is performed by using the timecode returned to the