JLCooper ES-450SP - Manual (Page 11)

11
ES-450SP by the machine. The frame rate must be set for this
function to operate properly. To set the frame rate, press SHIFT +
EJECT. This setting is stored in nonvolatile memory.
There are two ways to perform this based on the ballistics of the
controlled deck: “Cue Up” mode and “Slo Mo” mode. These can
be selected by pressing SHIFT + STOP. This setting is also stored
in nonvolatile memory.
The default method is “Cue Up” mode. In this mode, the ES-
450SP sends a Locate command that is incremented or
decremented by one frame. This works well for hard disk based
systems and newer decks.
The alternate method is “Slo Mo” mode. In this mode, the ES-
450SP sends a shuttle slow command in the appropriate direction.
The ES-450SP sends a STILL command when the machine
responds with timecode that is incremented or decremented by one
frame. This is better suited for older decks that have trouble with
locating a short distance.
Note:
If the machine does not use the timecode it sends out of the
remote connector as the locate reference, the machine will
locate to the wrong point. An example of this would be a
machine that sends VITC timecode to the remote, but uses
LTC to locate.
MARK IN and MARK OUT buttons send Mark In and Mark Out
commands to the machine. These are used to set points used in
Preview and Autoedit operations.
The PREVIEW button sends a Preview command to the machine.
This allows the operator to preview an edit. Typically, this
command causes the machine to perform the following actions:
1. Locate to the Mark In point minus the pre roll
2. Enter Play mode