JLCooper ES-450SP - Manual (Page 13)

13
Locate Functions
The ES-450SP can store up to seven locate points internally.
These locate points are stored as long as the unit is powered.
The locate buttons are secondary functions of the Editing Controls.
The locate buttons are identified in the following table:
Mark In Locate 1
Preview Locate 2
Frame-1 Locate 3
Shuttle Select Locate 4
Frame+1 Locate 5
Autoedit Locate 6
Mark Out Locate 7
Locate points are set by pressing and holding REC/SHIFT then the
desired locate button. Locate points are recalled by pressing
GOTO then the desired locate button. Locate points are stored in
memory as long as the unit is powered.
Direct Numeric Entry
The ES-450SP can also command the machine to locate to an
arbitrary timecode position. This is initiated by pressing the
GOTO button. The display will show:
GoTo : : :
Using the Transport and Track Arming Buttons, key in the desired
timecode then press ENTER. The machine will immediately go to
the entered timecode.