JLCooper CX Eclipse - Manual (Page 9)

9
5. The Port number will now appear as a five-digit number. If
you do not wish to change it, press ENTER. If you do wish
to change it, it must be entered as a five-digit number. For
instance, if you wish for port #80, you must enter 00080. If
a mistake is made, press the CLEAR button once.
6. After the ENTER key is pressed this last time, the changes
will be made to internal non-volatile memory, and a
message will appear.
As the message indicates, the changes will not take place on the
Ethernet Card until the power has been turned off and back on.
If you cannot access the Eclipse CX, please refer to the
troubleshooting section.
Configuring the Host Application
Now that the IP settings of the Eclipse CX have been set, the host
application must be configured to connect to the Eclipse CX.
To configure Apple Color to connect to the Eclipse CX, refer to
Appendix C, “Setting Up a Control Surface“ in the Apple Color
User Manual.