JLCooper CX Eclipse - Manual (Page 8)

8
Configuring the Eclipse CX
Before using the Eclipse CX, it must be configured properly.
To set initialize the Eclipse CX to factory defaults, perform the
following steps:
1. Holding the Up and Down buttons,
2. switch the Power switch on,
3. release the Up and Down buttons.
The factory defaults are:
IP Address 192.168.254.101
Subnet Mask 255.255.255.0
Gateway 192.168.254.198
To configure the IP address of the Eclipse CX, press SHIFT and
ASSIGN/UTILITY on the Eclipse CX.
To change the IP address or port of the Eclipse CX, perform the
following steps:
1. While the unit is powered, hold down the SHIFT key and
press the ASSIGN/UTILITY button.
2. The current IP Address will be shown in the display. If you
do not wish to change this address, press ENTER.
3. If you wish to change this, press numeric pad keys. This
does not scroll. If you make a mistake, press the CLEAR
button once, and the current number will reappear.
4. When satisfied with the displayed value, press the ENTER
key. The display will then display the Gateway value. If
you don't wish to change this, press ENTER again. Press
ENTER again to step past the Subnet Mask.