JLCooper KeyShot - Manual (Page 12)

12
4. Select the XPort item that corresponds to the hardware or MAC
address of your JLCooper Ethernet Controller and click on
Assign IP. The hardware or MAC can be found on the
Ethernet card.
5. Enter the IP address you want assigned to your Ethernet
Controller and click OK. In this example, we are using
192.168.254.165 however, you can use any address.
6. Your device will disappear momentarily from the XPort
Installer window and reappear. During this time, the status bar
in the bottom left corner of the window will display “Waiting
for reboot…”.