Jetway Computer NF98 - Manual (Page 31)

26
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
► Super I/O Configuration
Serial Port
Use this item to enable or Disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Serial Port Mode Select
Use this item to set serial port as RS232 or RS422/485.
CIR Controller
Use this item to enable or disable CIR controller.
► PC Health Monitor
Press [enter] to view hardware health status.
► Voltage Configuration
CPU Vcore 7-Shift
Use this item to adjust CPU voltage by 7 step value.
AGX Voltage
Use this item to adjust AGX voltage by 7 step value.
PCH Core Voltage
Use this item to select a value for PCH core voltage.
DRAM Voltage select
Use this item to select a value for DDR3 DRAM voltage.