Jetway Computer NF83 - Manual (Page 34)

29
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select [Manual] you can set value for the following sub-item: Device Power-up
delay in seconds, the delay range in from 1 to 40 seconds, in one second
increments.
► Acoustic Management Configuration
Menu for configuring Automatic Acoustic Management. Press [Enter] to enable or
disable Automatic Acoustic Management.
Automatic Acoustic Management
The optional settings are: [Enabled]; [Disabled].
► Second Super IO Configuration
Press [Enter] to make settings for the following sub-items:
► COM3 Port Configuration /COM4 Port Configuration / COM5 Port
Configuration /COM6 Port Configuration
Serial Port
Use this item to enable or Disable serial port.
Change Settings
Use this item to select an optimal setting for super IO device.
Select RS232/RS422/RS485
Use this item to select serial port RS232/RS422/RS485 mode.
The optional settings are: [RS422]; [RS232];[RS485].
Mode Speed Select
Use this item to select serial port RS232/RS422/RS485 speed.
The optional settings are: [RS232/RS422/RS485=250Kbsp]; [RS232=1Mbsp,
RS422/RS485=10Mbsp].
*Note: Select RS232/RS422/RS485 and Mode Speed Select options are only
optional for COM6 port.
► Super I/O Configuration
Press [Enter] to make settings for the following sub-items: