Dixon 3000 Series - Manual (Page 13)

SPECIFICATIONS
Model ZTR 3362
CHASSIS: The monocoque design chassis of the 3000 Series Models incorporates CNC
Laser and CNC brake processes to form the twin 12 gauge side frames and 7
gauge transmission and engine base plate.
BODY: All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
MOWER DECK: 11 GA stamped steel construction.
36" Cut width. Cut height approximately 1" to 4" via 7 position lift
handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by chain and sprockets through a friction
mechanical drive.
ENGINE: 13 HP Briggs & Stratton Diamond Plus, 4-Cycle, Single Cylinder, Air-Cooled,
Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced, Laminated
Shroud.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and blade
drive.
TIRES: Front 410 X 3.50 X 4 ribbed tread.
Rear 18 X 8.50 X 8 Multi Trac tread.
CAPACITIES: Fuel - 2.0 gallons total.
Engine: 1.25 quarts oil.
DIMENSIONS: Width 43.0" outside rear wheel measurement.
Height 36.0" to top edge of seat.
Length 65.5" hitch tab to front bumper.
Weight 500 lbs.
NOTE: Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
Page 10