Ivoclar Vivadent IvoBase Injector - Manual (Page 13)

13
4.5 Initial start-up
1. Connect the power cord (13) with the wall socket.
2. Put the On/Off switch (20) on position "I".
Immediately after switching on, the display shows the start screen
for a few seconds.
The injector now conducts an automatic self-test. During the test,
the performance of all injector components is automatically
checked. The display shows the following indications during the
self-test:
a) Software version
b) Progress bar
c) Power supply voltage
d) Number of injections performed
If the program recognizes an error or a hint, the corresponding
information (e.g. "Hint 1700") appears on the display. If all
components are in order, the display will go to stand-by mode and
an acoustic signal will sound.
Make sure that the safety door is always closed during
the self-test.
Stand-by indicator
The stand-by indicator is shown after the self-test, and the last
program used before switching off will be loaded.
a) Status of the injector
b) Program number
c) Possible key strokes
d) Program name
a)
b)
c) d)
d)
a)
b)
c)