Ivoclar Vivadent IvoBase System - Manual (Page 2)

IvoBase
®
System Short Instructions
4
Mixing the material
5
Loading the injector
Injection and
polymerization
Divesting
– Remove the monomer
container from the capsule
– Remove the capsule seal
– Twist off the sealing cap of
the monomer container
– Pour the monomer into the
open capsule
– Use the spatula to mix the
monomer and polymer in the
capsule to a
homogeneous
mixture for approx. 20–30 s
– Place capsule on an even
surface
– Place flask with the centering
insert on the capsule
– Insert the flask into the
polymerization chamber until
it stops
– Close the door of the Injector
– Select the program
– Activate "RMR" key, if desired
– Start
– Start of the program with the
expansion phase
– Remove the flask at the end
of the program
– Cool in cold water for
15 min.
– Remove the locking clasps
– Secure the flask in the dental
press with the divesting aid
– Lift the upper flask half by
levering it on both sides in the
gap between the flask halves
– Turn over the flask
– Repeat the procedure
– Remove the stone core and
separate capsule
– Divest the dentures from the
stone core using stone tongs
– Finish and polish dentures as
usual
Please refer to the Instructions for Use for more detailed information
Ivoclar Vivadent AG
9494 Schaan/Liechtenstein
639389/e/2012-12-06/Rev. 0
Program
No. Material Duration Duration
with
RMR*
1 IvoBase Hybrid 35 min 45 min
2 IvoBase High Impact 50 min 60 min
3 SR Ivocap High Impact 55 min 65 min
4 SR Ivocap Clear 55 min 65 min
5 SR Ivocap Elastomer 65 min –
6-20 Ivoclar Vivadent – spare
* With the RMR function (residual monomer reduction) the residual monomer content is reduced to below 1%.