Insinger Commander 18-6 - Manual (Page 47)

DoorTypeTM2013 www.insingermachine.com 800-344-4802 45
PART 4 ELECTRICAL SCHEMATICS
& REPLACEMENT PARTS
CONVERT 18-6 STRAIGHT TO CORNER
DOOR CONVERSION
All 3 doors open on a straight machine; only the
front & right hand doors are used on a comer. The
front is defined as facing the center door with the
springs on the back. Remove the door connector
bracket between the left & front doors. Fill the holes
with the screws, flat washers & nuts. Disconnect the
link between the left door stud and the handle and
remove it. Back off the tension on the springs on the
back of the machine. Test the operation of the doors.
It may be necessary to remove the springs and turn
the mounting angle upside down. Use 2 people, a 1/2
diameter rod and extreme care if disconnecting and
reattaching springs. Be sure the door magnet is on
an operating door.
TRACK CONVERSION
Current Track Assembly #1550-28 rev A: remove item
#3 Track Fence from its position on the front track &
insert the studs into the holes on the left hand cross
track (at the non-opening door). The angle must face
toward the inside of the machine. The rack will be
sliding over the surface of this angle.
Early Track Assembly #1550-28 rev 0: remove
#1550-14-2 vertical and discard. Install #1550-14-3
cross track - closed end on the left (at the non-open-
ing door). Install #1550-14-5 cross track - open end
on the right (at the opening door). Track arrangement
should now match the view on the left of the drawing
‘CORNER SET-UP’. If any parts are missing, contact
[email protected] or call 215-624-4800.
LEFT/RIGHT CONFIGURATION
See Installation Drawing 18-6C. Note how the
machine is positioned in a left hand comer. It is
rotated 90 degrees clockwise for installation into a
right hand comer. This constitutes the conversion
procedure.
®