Insinger Commander 18-6 - Manual (Page 12)

PART 2 INSTALLATION INSTRUCTIONS
DoorTypeTM2013 www.insingermachine.com 800-344-4802
Chemicals
Upon the completed installation of the dishwasher,
contact a local detergent/chemical supplier for the
correct chemicals for your soil load and geographical
area.
Electrical connection points for the detergent
dispenser and rinse injector are located inside the
control panel. Refer to the wiring diagram for this
machine for the proper connection points.
Dispensers may be connected on either the primary
voltage side of the machine or the 24VAC control
voltage side.
Mechanical Connections
Connect hot water (see specific unit info) lines for tank
fill/booster as tagged and noted on the installation
drawings. If machine is provided with steam heat
connect the steam lines and steam condensate lines
as tagged and noted on installation drawings. Connect
the drain line.
10
CAUTION:
As with any 3 phase system, an electrician must check
all motors for proper phasing, i.e., Pump motors must be
running in direction indicated by arrow on housing.
CAUTION:
Drain lines must be as specified on installation
drawings.
Drain line should be properly vented and should have
fall of not less than 1/4” to the foot of proper flow.
Some area plumbing codes require drains
to flow into an open gap with an opening twice
the diameter of the pipe.
Check with your local plumbing codes for the type of
drain connection required.
CAUTION:
All lines must be flushed prior to use to remove debris.
CAUTION:
Do not reduce the size of lines as specified in installa-
tion drawings. All Lines are sized to facilitate necessary
flows, pressures, etc.
HVAC
Ventilation system must be sized to provide adequate
ventilation per machine specs. Refer to spec sheet.
CAUTION:
When connecting on the 24VAC control voltage side of
the transformer, total VA must not exceed 50VA.
The detergent density probe should be installed in the
hole provided & labeled in the wash tank. A switch on
the control panel labeled “De-lime” is provided for de-
liming the machine. When activated, this switch will
keep the machine in an indefinite wash cycle. A switch
on the control panel labeled “Heavy Cycle” provide an
extended 2 minute wash cycle.
Tabling
Load and unload tables should be pitched towards the
machine to return excess water into the machine.
Insinger dishmachines are user-friendly, making
them easy to operate and maintain. By following the
operation procedure and general cleaning procedures
your Insinger dishwasher will give you years of trouble
free service.
®