Dayton WT3 - Manual (Page 18)

Edit Menu
The commands under the Edit menu are as follows:
Undo (Ctrl+Z)
Undo is not implemented
Cut (Ctrl+X)
Cut is implemented for various text fields. Text is cut and placed on the clipboard for pasting to
another location if desired
Copy (Ctrl+C)
Copy is implemented for various text fields. Copied text is placed on the clipboard for pasting to
another location
Paste (Ctrl+V)
Paste is implemented for various text fields. Use this command to paste text that has been placed on
the clipboard
Open the Driver Editor (Ctrl+D)
Opens the Driver Editor for access to a fully detailed set of driver data. Besides the measured driver
parameters there are fields for you to enter as much additional data as you wish. Each of the 20
memories in a project file holds its own complete set of driver data. When you save a driver file the
complete set of data is saved to a .dvr file which can be opened by the popular loudspeaker design
program WinSpeakerz. Similarly, individual driver files saved by WinSpeakerz can be opened in WT3.