IHSE USA 485 Series Repeater and Cross Repeater User Manual
Page 22
Draco (Cross) Repeater
22
2014-04-15
4 Installation
Pos: 27 /806-IHSE/Installation/Lieferumfang prüfen/485-xx @ 11\mod_1395155216299_6.doc @ 141092 @ 2 @ 1
4.1
Package Contents
Your extender package contains the following items:
(Cross) Repeater:
(Cross) Repeater in the vario chassis
1x (redundancy 2x) 5 VDC international power supply unit per KVM
Extender unit (depending on chassis)
1x (redundancy 2x) country-specific power cord (depending on
chassis)
Quick
Setup
If anything is missing, contact your dealer.
Pos: 28 /806-IHSE/Installation/System anschließen/485-xx @ 11\mod_1395155663403_6.doc @ 141123 @ 23 @ 1
4.2
System anschließen
First time users are recommended to setup the system in the same room
as a test setup. This will allow you to identify and solve any cabling
problems, and experiment with your system more conveniently.
Please verify that interconnect cables, interfaces, and handling of the
devices comply with the requirements (see Chapter
4.2.1 (Cross) Repeater Setup
1. Switch off all devices.
2. Connect the (Cross) Repeater with the interconnect cable(s).
3. Connect the chassis of the (Cross) Repeater to the power supply.
4. Power up the system.
To power up the system, the following sequence is recommended:
Monitor – CON Unit – (Cross) Repeater – CPU Unit – source.
Pos: 29 /806-IHSE/Installation/Installationsbeispiele/485-xx @ 11\mod_1395156295171_6.doc @ 141154 @ 2 @ 1