IHSE USA 470 Series CWDM MUX/DEMUX - Manual (Page 11)

INSTALLATION
11
3.3 System Setup
To install your CWDM MUX/DEMUX –system:
1. Switch off all devices.
2. Install the CWDM MUX/DEMUX Transceivers in the Local and Remote units. Each
wavelength must not appear more than once in the system. Device pairs must carry
transceivers with the same wavelength.
Each wavelength (1531, 1551, 1571, 1591nm) must not be used more than
once at each side! For 4 links, please us 4 different wavelengths, for 3 – 3
different wavelengths and for 2- 2 different wavelengths.
Each transceiver will work only at the appropriate port
The data will always flow between devices with the same wavelengths
3. Connect interconnection cables from Remote/Local unit to CWDM MUX/DEMUX Box
– please mind that you connect the transceivers to the matching port at the CWDM
MUX/DEMUX Box.
4. Connect Local and Remote CWDM MUX/DEMUX units with matching interconnection
cable (Singlemode Fiber).
5. Power up the system.
CWDM MUX/DEMUX Type K470-CW Unit
3.4 Diagnostics
There are no diagnostic possibilities at the CWDM MUX/DEMUX box. Please use the
diagnostic possibilities of the attached units
Port
1531nm
Interconnect Port
1551nm
Port
1571nm
Port
1591nm