IBASE SMARC Evaluation Kit - Manual (Page 14)

Copyright © 2013 IBASE Technology Inc. All Rights Reserved. 14
14 SMARC Evaluation Kit
1.6. Installing the SMARC
The MXM3.0 connector on RP-100-SMC supports the SMARC form factor (82mm x
50mm and 82mm x 70mm).
To install SMARC modules to the MXM slot on the board, please perform the
following steps:
 Hold the SMARC module so that the golden fingers of the SMARC module
aligned with the MXM connector.
 Gently push the SMARC module to the MXM connector in 45 degree angle
position until the golden finger of SMARC completely touch the bottom of the
slot.
 Gently press the SMARC module down and fix it with four screws.