IBASE IB831 - Manual (Page 40)

BIOS SETUP
36 IB831 User’s Manual
BIOS SETUP UTILITY
Main
Advanced
PCIPnP Boot Security Chipset Exit
Configure Remote Access type and parameters
Select Remote Access
type.
<- Select Screen
↑↓ Select Item
+- Change Field
Tab
Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Remote Access [Enabled]
Serial port number [COM1]
Base Address, IRQ [3F8h, 4]
Serial Port Mode [115200 8,n,1]
Flow Control [None]
Redirection After BIOS POST [Disabled]
Terminal Type [ANSI]
VT-UTF8 Combo Key Support [Enabled]
Sredir Memory Display Delay [No Delay]
When enabled, the Remote Access type and parameters are shown:
Serial port number - Select Serial Port for console redirection.
Serial port mode - Select Serial Port settings.
Flow Control - Select Flow Control for console redirection.
Redirection After BIOS POST
Disable: Turns off the redirection after POST.
Boot Loader: Redirection is active during POST and during Boot
Loader. Always: Redirection is always active. (Some OSs may not
work if set to Always.)
Terminal Type - Select the target terminal type.
VT-UTF8 Combo Key Support
– Enable VT-UTF8 Combination
Key Support for ANSI/VT100 terminals.
Sredir Memory Display Delay
– Gives the delay in seconds to
display memory information.