Dacor ACS363 - Manual (Page 18)

16 17
Table 5: Troubleshooting Guide (Continued)
First, review the recommended checks listed in the preceding Troubleshooting Guide. Then, be certain that the appliance has been installed
properly and is being operated correctly. Familiarize yourself with the warranty terms and conditions listed in the PRODUCT WARRANTY
section.
If the above checks have been completed and the problem has not yet been remedied, call your local authorized DACOR service
representative. Your dealer can normally provide the name and telephone number of the nearest service company.
DACOR works diligently to ensure your satisfaction when service is necessary. However, if you are not completely satisfied with the service
provided, contact the company that performed the service and express why you are not pleased. Normally, they will be willing and able
to resolve the problem.
If the service agency is not able to respond effectively, call or write the DACOR Customer Service Department. The phone number and
address of this department are listed on the inside front cover of this manual. Please include your telephone number if you choose to write. We
will then do our utmost to assure your happiness and satisfaction.
Problem
9. Oven will not heat after Self
Cleaning
Possible Cause
Time of day is not set due to power failure.
Oven settings are not correct.
Remedy
Press “CLOCK” touch pad, then press
“TIME•TEMP” pad to set correct time of day.
Follow mode selection and clock settings as
specified in the OVEN OPERATION section.
Oven will turn on automatically at preset time.
If desired, press “CANCEL•SECURE” touch pad
to cancel out of Delay Timed mode.
Troubleshooting
(Continued)
Product Maintenance
No maintenance, other than the CARE AND CLEANING INSTRUCTIONS identified in this Use & Care Manual, should be attempted by the
owner/operator. All other maintenance and service must be performed by a qualified appliance technician.
If You Need Service...
Clock Display Cause
F0. Touch pad is stuck in a depressed position
F1. Relay circuit failure.
F2. Oven temperature exceeded the clean runaway temperature (Self-Clean mode only)
or the cooking runaway temperature (cooking modes only).
F3. Short circuit in the oven temperature sensor.
F4. Open circuit in the oven temperature sensor.
F6. Failure in the EEPROM check comparison. (Only time of day and timer will operate.)
F7. Failure of the Self-Clean automatic door latch circuit.
F8. Failure of the door latch motor. Occurs when the motor runs for two minutes without
the door locking in Self-Clean mode.
Table 6: Oven Failure Codes