Engine oil, Checking engine oil – Hummer 2007 H3 User Manual
Page 323
A. Windshield Washer Fluid Reservoir. See
“Adding Washer Fluid” under Windshield
Washer Fluid on page 346.
B. Engine Coolant Recovery Tank. See Engine
Coolant on page 335.
C. Engine Air Cleaner/Filter. See Engine Air
Cleaner/Filter on page 328.
D. Power Steering Fluid Reservoir. See Power
Steering Fluid on page 345.
E. Automatic Transmission Fluid Dipstick (If
Equipped). See “Checking the Fluid Level” under
Automatic Transmission Fluid on page 329.
F. Engine Oil Fill Cap. See “When to Add Engine
Oil” under Engine Oil on page 323.
G. Radiator Pressure Cap. See Cooling System
on page 340.
H. Remote Negative (
−
) Terminal (GND). See
Jump Starting on page 352.
I. Engine Oil Dipstick. See “Checking Engine Oil”
under Engine Oil on page 323.
J. Positive (+) Battery Terminal. See Jump
Starting on page 352.
K. Brake Fluid Reservoir. See “Brake Fluid” under
Brakes on page 347.
L. Engine Compartment Fuse Block. See Engine
Compartment Fuse Block on page 418.
M. Battery. See Battery on page 351.
N. Hydraulic Clutch Fluid Reservoir (If Equipped).
See Hydraulic Clutch on page 334.
Engine Oil
Checking Engine Oil
It is a good idea to check the engine oil every time
you get fuel. In order to get an accurate reading,
the oil must be warm and the vehicle must be
on level ground.
The engine oil dipstick handle is a yellow loop.
See Engine Compartment Overview on page 322
for the location of the engine oil dipstick.
1. Turn off the engine and give the oil several
minutes to drain back into the oil pan. If you
do not do this, the oil dipstick might not
show the actual level.
2. Pull out the dipstick and clean it with a paper
towel or cloth, then push it back in all the
way. Remove it again, keeping the tip down,
and check the level.
323