HUBER+SUHNER MASTERLINE Ultimate Hybrid - Manual

HUBER+SUHNER disclaims any liability resulting from incorrect installation and use, including any damages resulting from the use of
tools and accessories other than the ones recommended herein. Any installation performed by unqualified personnel voids the product
warranty provided by HUBER+SUHNER. All due care and attention must be exercised when performing the installation of these pro-
ducts. For advice concerning the general handling of these products please contact HUBER+SUHNER.
INSTALLATION
MANUAL
INSTALLATION OF RRH END OF ASSEMBLY
Step 1
Mount the cable spool onto suitable de-reeling equipment.
Start unwinding side where the braided tube is attached (picture to
the right). Do not pull side where pulling tube is attached. Make
sure, that the spool can turn freely when unspooling.
Step 2 Remove the MLUH connector head from the mounting bracket by
unscrewing the two fixing screws.
Screws are retained by integral retaining washers.
Step 3 Secure the mounting bracket with hoseclamps (when fitting to a
pole/mast) or srews (when lifting to a wall).
Various mounting slots provided for different pole diameters.
Comment: take length of break-out and jumpers in consideration
when the bracket is positioned on the mast.
HUBER+SUHNER AG
Fiber Optics
MASTERLINE Ultimate Hybrid
DOC-0000692201 Rev B
April 20, 2015
Page 1 of 12
Table of contents
INSTALLATION OF RRH END OF ASSEMBLY 1
BASE STATION END OF ASSEMBLY 3
FIBRE OPTIC ALLOCATION 8
POWER CODING 9
MASTERLINE Ultimate Hybrid