Directed Electronics 5 - Manual (Page 24)

21 © 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
2. Enter PIN - Enter the factory preset PIN code of 2 by press-
ing
on the PlainView 2 Valet switch twice, then
once.
3. Hold/Chirp/Release - After entering the PIN code, press and
hold
until a chirp is heard and the LED turns on, then
release the button. You have now entered the feature selec-
tion position of the User Selectable Features grid.
4. Column select - Press the same number of times as the
desired column. After a pause the siren will chirp the same
number of times as the selected column for confirmation.
5. Feature select - Press the same number of times as the
desired feature. The siren will chirp with each press. The fea-
ture can now be changed using the remote control.
6. Feature change - Press on the transmitter. If the sys-
tem chirps once, the feature has just turned off; if the sys-
tem chips twice, the feature has just turned on. If the fea-
ture has more than two settings, continue pressing
on the transmitter to toggle through the settings.
You can advance to any feature in the same column by
pressing
within 60 seconds; to program a feature in a
different column begin at step 4 within 60 seconds.
7. Exit programming - To exit programming mode turn the igni-
tion off or wait 60 seconds without pressing the PlainView 2
Valet switch. The siren will chirp three times to indicate pro-
gramming mode has been exited.
nnoottee:: Refer to the Feature Descriptions sections of this guide for impor-
tant notes and descriptions of the system features and programming.