Directed Electronics 5 - Manual (Page 18)

15 © 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
Press on the PlainView 2 Valet switch while playing the desired
sound to add that sound; press while playing the desired sound to
delete that sound.
diagnostics
The microprocessor at the heart of your security system is constantly
monitoring all of the switches and sensors that are connected to it. It
detects any faulty switches and sensors and prevents them from dis-
abling the entire system. The microprocessor will also record and report
any triggers that occurred during your absence.
arming diagnostics
If the system is armed while an input is active (door open, sensor trig-
gering, etc.) the unit will chirp twice when arming and then four more
times five seconds later. This is called Bypass Notification.
The security system will ignore the input that was active when the sys-
tem was armed, until the input goes away. Three seconds later the sys-
tem will monitor that input normally. For example, if your vehicle has
interior light exit delay, and you arm the system before the interior light
goes out, you may hear Bypass Notification chirps. Once the light shuts
off, however, the doors are monitored normally.