Directed Electronics 5 - Manual (Page 19)

16
disarming diagnostics
Extra disarm chirps are the Tamper Alert. If three chirps are heard when
disarming, the system was triggered in your absence. If three chirps are
heard, the LED status indicator will indicate which zone was involved
(see the Table of Zones section). The system will retain this information
in its memory. Refer to the Multiple Event Total Recall section of this
guide.
arm/disarm diagnostic chart
table of zones
The zone number is the number of LED flashes used by the system to
identify a specific input. The standard input assignments are listed
below, along with spaces to write in any optional sensors or switches
you have had installed. If the Warning Zone response is triggered, the
LED will not report it.
Action Chirps Light Flashes Description
Arm 2 2 System armed
Arm 4 4 System armed with hood/
trunk active and bypassed
(zones 5 and 6)
Arm 2 (5 sec.) 4 2 (5 sec.) 4 System armed with door
active and bypassed (zone 4)
Arm 2 (10 sec.) 4 2 (10 sec.) 4 System armed with sensor
active and bypassed zones
3 and 8
Disarm 1 1 System disarmed
Disarm 3 3 System disarmed with
tamper alert
Disarm 5 5 System disarmed with low
battery warning