HP Velotechnik Go SwissDrive system for HP Velotechnik User Manual

Page 26

Notes for the user

Charging begins as soon as the connection is
established.

Note: Please bear in mind that mobile
phone charging cannot take place unless
your GO

WISS

RIVE

motor system is

switched on. The maximum charging
current is 1.1 A. The maximum charging
voltage is 5.5 V.

Note: The availability of the charging
function depends on whether it is
supported by your vehicle. For safety,

some wiring harnesses may have built-in
fuse protection, which can significantly
restrict the available charging current.

General notes on system handling

Treat your Evo control device with the
necessary care. The housing is made from
plastic and it contains sensitive electronic
components. Do not attempt to reshape or
drill through it, avoid exposure to naked
flames and liquids and be careful not to drop
it.

In the event that it is damaged, refrain from
further use of your Evo control device, as

unforeseeable defects could develop.

Do not remove or fit the display in areas with
a potentially explosive atmosphere (e.g. fuel
stations).

The display of your Evo control device is
rated IP 65 for dust and splash water
protection. Nevertheless, you should remove
the display from the holder and store it in a
safe place before transporting your e-bike or
s-pedelec by car or trailer as the air flow in
this situation could cause significant pressure
differences, which could allow the ingress of
dust and water into the housing.

Refrain from placing the display on the
docking station if the contact surfaces are

damp or dirty. Otherwise, malfunctions could
occur during the ride.

Do not carry the display together with sharp-
edged items (keys, pocket tools)

Avoid exposing the display to high
temperatures, e.g. keep it away from sources
of heat and do not leave it next to car
windows in conditions of strong sunlight.

Make sure that no moisture enters through
the USB opening in the holder. The USB port
should be kept sealed with the cap when it is
not being used.

Care and maintenance of the Evo
control device

Notes on care

Clean your Evo control device immediately if
comes into contact with any substances that
could lead to staining (e.g. thinner, petrol, ink,
makeup, etc.). Use a soft, lint-free cloth for
cleaning.

Do not use alcohol-based cleaning agents,
chemical cleaning products or abrasive
materials as these could damage the display.

Do not use pressure jets or compressed air
for cleaning.

Note: Keep the USB cap sealed at all
times during cleaning

Notes on maintenance

Your Evo control device is generally
maintenance-free with the exception of the
replaceable internal battery. To have the
battery exchanged, you should take your Evo
display to an authorised specialist dealer.

Never attempt to repair your Evo control
device yourself. Opening the display, docking
station or remote control will void all
warranties, whether express or implied. In the
event that maintenance work is required, this