HP Velotechnik Go SwissDrive system for HP Velotechnik - Manual (Page 25)

Notes for the user
23
To find out whether your mobile phone
supports the Bluetooth 4.0 standard, please
consult the user guide for your mobile phone.
For details on how to establish a connection,
please refer to "Configuration and setup
options" from page 20 onwards.
Incoming telephone calls:
With your control device connected to a
mobile phone by Bluetooth, notification of
incoming phone calls on this phone will
appear as a pop-up on the Evo display. If the
number of the caller is stored in the contacts
list on this mobile phone, the pop-up will
show the contact details (surname, first name)
assigned to this number. If the telephone
number is not stored in the contacts list, only
the number will be displayed.
Incoming SMS:
With your control device connected to a
mobile phone by Bluetooth, notification of
incoming SMS on this phone will appear as a
pop-up on the Evo display. If the number of
the sender is stored in the contacts list on
this mobile phone, the pop-up will show the
contact details (surname, first name) assigned
to this number. If the telephone number is
not stored in the contacts list, only the
number will be displayed.
Battery charge state information:
Whenever the battery charge of your
GO S
WISS
D
RIVE
motor system falls below
20%, you will be informed by a pop-up to this
effect. Another message in the form of a pop-
up will appear if the charge state of the
battery drops below 10%.
Data storage:
Your Evo control device enables you to save
your current trip data and overall data to an
external device via the USB or Bluetooth
interface. A display pop-up confirms that the
data were saved to the external device
successfully. Where relatively high data
volumes are being saved, separate pop-ups
will appear to mark the start and successful
completion of the saving process. If an error
occurs during the saving process, notification
will be given again in the form of a pop-up.
No external device connected:
If you try to save data via the USB or
Bluetooth interface without an external
device connected to this interface, a
notification to this effect will be displayed in
the form of a pop-up.
Advance warnings:
As an early safeguard against possible
overloading of your GO S
WISS
D
RIVE
motor
system, advance warnings may be issued by
your Evo control device. In particular, these
include the motor and battery overheating
warning. Before the motor or battery
overheats and in order to protect the system,
power is reduced and the display informs you
accordingly.
Note: Adapt your riding style and/or
assistance levels as instructed if you wish
to avoid a temporary power reduction or
total loss of assistance. You can do this
either by lowering the assistance level or
by shifting down into a gear with a lower
gear ratio in order to reduce the
temporary overloading of drive
components.
Charging a mobile phone via USB
connection
The docking station of your Evo control
device has a USB interface. The USB interface
can be used not only to transfer data but also
to charge a mobile phone. To do this, connect
the mobile phone to the USB interface of the
docking station using a compatible USB cable.