Delta BS150LS - Manual (Page 8)

8
ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
T H E M A C H I N E I S C O M P L E T E LY A S S E M B L E D A N D Y O U R E A D A N D U N D E R S TA N D T H E E N T I R E
INSTRUCTION MANUAL.
STAND ASSEMBLY
1. Assemble stand as shown in Fig. 4, using parts
shown in Fig. 3. The brackets and legs are identified with
the same letter in both illustrations. Insert the M8 x
16mm carriage head screws through the legs and the
brackets then place the 3/8" flat washers on the screws
and secure with the M8 hex nuts. Only tighten nuts
finger-tight at this time. NOTE: The top lips of top
brackets (A) must fit on top of the front and back
brackets (B).
2. Attach the four plastic feet (1) Fig. 4 to the bottom of
each leg (L).
Fig. 4
BAND SAW TO STAND
ASSEMBLY
1. Fig. 5 illustrates the four through holes (A) which will
be used to secure the band saw to the stand.
A
A
2. Place the band saw on top of the stand and line up
the holes (A) Fig. 5 with the holes (D) Fig. 6 on the top
brackets of the stand.
Fig. 5
Fig. 6
D
D
E
A
B
L
C
1