beautypg.com

Chopper current test -15 – Hypertherm RoboTester Troubleshooting Kit User Manual

Page 27

background image

RoboTester

Instruction Manual

3-15

SETUP AND OPERATION

0

Figure 17

I/O Board shorted out with DC short wire

Chopper current test

Checks the current output of each chopper. Chopper 1 is tested a 30-amps and Chopper 2 is tested at 100-amps.
If proper current is detected the choppers are functioning properly.

Items Needed: See parts list for details

#1 4/O Jumper Cable

Set-Up

1 – Remove Negative and Work Lead 4/O cables from large brass bus bars inside HD4070
2 – Install 4/O Jumper Cable across buss bars in place of Negative and Work Leads