Hypertherm RoboTester Troubleshooting Kit - Manual (Page 15)

RoboTester Instruction Manual 3-3
SETUP AND OPERATION
0
System Set-Up: Full system or power supply only
Enables testing of the entire plasma system
Items needed: See parts list for details
#16 I/O Shunter Diskette
#25 Null Modem Dongle
#26 CNC Dongle
#29 Extension Cable
#29a optical Isolator
Set-Up
1 – Remove top and side panels from power supply.
2 – Connect the Optical Isolator to the communication port on the laptop computer.
3 – Connect Extension Cable to the Optical Isolator..
4 – Connect opposite end of Extension Cable to Null Modem Dongle.
5 – Connect Null Modem Dongle to J7 on Breakout board (PCB6).
6 – Install CNC Dongle,If no CNC cable is connected to power supply.
7 – Make sure all door switches (3) are satisfied.
8 – Insert the I/O Shunter Diskette into floppy disk drive.
9 – Turn power on HD4070 and wait until floppy disk is loaded into the HD4070 system.
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect electrical power before performing any maintenance.
All work requiring removal of the power supply cover must be performed by a
qualified technician.
See Section 1 of the Operator Manual for more safety precautions.
Note: The RoboTester software is only compatible with Windows ’95, ’98 and NT.
The laptop computer being used must have a serial communication port.
Caution: Failure to use the Optical Isolator when connecting to
the laptop can cause the communication port to be
destroyed.