Hypertherm HySpeed HT2000 Plasma Arc Cutting System Rev.7 User Manual
Page 37

ORDERING PROCEDURE
2-18
HySpeed HT2000
Product Configuration Manual
6
Specify the Timer/Counter
This unit allows the operator to monitor the number of arc starts and the cumulative time that the arc is on
in hours.
• The timer/counter usually rests on the power supply. Order the timer/counter.
Specify the Timer/Counter Cable
• Order the timer/counter cable.
Specify the Water Muffler (WM) System
The water muffler for the HT2000 system is an option which greatly improves cutting safety and pollution
control capabilities. A water table must be installed in order to use this option. The water muffler can be
used to cut both above and below water. Supply water is taken from the water table. The system consists
of a torch shield, a nozzle assembly, a water pump, a filter/strainer, a 50 ft (15 m) hose, and a 4 ft (1 m)
hose. Systems can be ordered with or without the hoses. See page 2-19 for system interface
configuration.
• Note: The water muffler system will not work with the stainless steel torch.
• Determine the voltage available at the site (for the pump), and whether the customer wants to provide
his/her own hosing or not. Order the appropriate system from the parts list on page 2-19.
• For installations requiring longer hose lengths, specify the additional length required with the appropriate
additional length part number.
Specify the WM Cable Between the WM Pump and Power Supply
• Based on the distance between the water muffler pump and the power supply, order the appropriate cable
from the parts list on page 2-19.
Specify the Hose Between Gas Supplies and Gas Console
Hypertherm offers hose to interface from the source gas supplies to the gas console.
• Order oxygen plasma gas hose.
23
a
23
22
21
a
21
21
20
a
20