Ordering information – Hypertherm HySpeed HT2000 Plasma Arc Cutting System Rev.7 User Manual
Page 24

ORDERING PROCEDURE
HySpeed HT2000
Product Configuration Manual
2-5
6
Ordering Information
To configure an HT2000 system for a particular site, use the following steps as a guide.
Each numbered step is cross-referenced in four areas: in the sample gantry system diagram on page 2-24; in block
diagrams to clarify interfacing components; in the accompanying parts lists; and in the specifications section to
clarify size and weight of major components. (Block diagrams are offered to clarify connection points and do not
necessarily reflect relative sizes or distances between components.)
Note:
If the cutting system has a power track for cabling and hosing, be certain to see the Specifications section
to check hose, cable and connector diameters.
Figure 2-3
HySpeed HT2000 System with Major Components in a Gantry Layout
Timer/Counter and
Argon/Hydrogen Console not shown.
Motor Valve Console
Torch w/IHS Probes
Water
Water Muffler
Pump
Water
Power
Power
Machine
Interface
HySpeed HT2000
Gas
Console
Remote
V/C
Gas
Gas
Air
IHS Air
Control
RHF
Console
Water Muffler
Nozzle
Torch
Timer/Counter and
Argon-Hydrogen Console not shown.