Daewoo DCR-9120 - Manual (Page 3)

3
Pr
oduct
Information
This set has been designed and manufactured to assure
personal safety. Improper use can result in electric shock or
fire hazard. The safeguards incorporated in this unit will
protect you if you observe the following procedures for
installation, use and servicing. This unit is fully transistorized
and does not contain any parts that can be repaired by the
user.
1 Read Instructions
All the safety and operating instructions should be read
before the unit is operated.
2 Retain Instructions
The safety and operating instructions should be retained
for future reference.
3 Heed Warnings
All warnings on the unit and in the operating instructions
should be adhered to.
4 Follow Instructions
All operating and use instructions should be followed.
5 Cleaning
Unplug this unit from the wall outlet before cleaning. Do
not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
6 Attachments
Do not use attachments unless recommended by the
unit’s manufacturer as they may cause hazards.
7 Water and Moisture
Do not use this unit near water- for example, near a
bath tub, wash bowl, kitchen sink or laundry tub, in a
wet basement, or near a swimming pool and the like.
8 Accessories
Do not place this unit on an unstable cart, stand, tripod,
bracket, or table. The unit may fall, causing serious injury
to a child or adult as well as serious damage to the unit.
Use this unit only with a cart, stand, tripod, bracket, or
table recommended by the manufacturer.
8A A unit and cart combination should be moved with care.
Quick stops, excessive force, and uneven surfaces may
cause the unit and cart combination to overturn.
9 Ventilation
Slots and openings in
the case are provided for
ventilation to ensure
reliable operation of the
unit and to protect it
from overheating. These
openings must not be blocked or covered. These
openings must not be blocked by placing the unit on a
bed, sofa, rug, or other similar surface. This unit should
never be placed near or over a radiator or heat radiator.
This unit should not be placed in a built-in installation
such as a bookcase or rack unless proper ventilation is
provided or the manufacturer’s instructions have been
adhered to.
10 Power Sources
This unit should be operated only from the type of power
source indicated on the marking label. If you are not sure
of the type of power supply to your home, consult your
dealer or local power company. For units intended to
operate from battery power, or other sources, refer to
the operating instructions.
11 grounding or Polarization
This unit is equipped with a polarized alternating -current
line plug (a plug having one blade wider than the other).
This plug will fit into the power outlet only one way. This
is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug still
fails to fit, contact your electrician to replace your
obsolete outlet.To prevent electric shock, do not use this
polarized plug with an extension cord, receptacle, or
other outlet unless the blades can be fully inserted
without blade exposure. If you need an extension cord,
use a polarized cord.
12 Power-Cord Protection
Power-supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or
against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they
exit from the unit.
13 Outdoor Antenna Grounding
If an outside antenna or cable system is connected to the
product, be sure the antenna or cable system is
grounded so as to provide some protection against
voltage surges and built-up static charges. Section 810
of the National Electrical Code, ANSI/NFPA No. 70-1984
(Section 54 of Canadian Electrical Code, Part 1) provides
information with respect to proper grounding of the
mast and supporting structure, grounding of the lead-in
wire to an antenna-discharge unit, connection to
grounding electrodes, and requirements for the
grounding electrode. See example as shown.
14 Lightning
For added protection for this unit during a lightning
storm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and
disconnect the antenna or cable system. This will prevent
PORTABLE CART WARNING
(symbol provided by RETAC)
Important Safeguards
2
Important Safeguards
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within
the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of
important operating and servicing instructions in the
literature accompanying the appliance.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
CAUTION : TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
IMPORTANT FOR LASER PRODUCTS
LASER
This Digital Video Disc Player employs a Laser System. To ensure proper use of this product please read this
owner’s manual carefully and retain for future reference. Should the unit require maintenance, contact an
authorized service location - see service procedure.
Use of control adjustments or the performance of procedures other than those specified may result in
hazardous radiation exposure.
To prevent direct exposure to the laser beam, do not try to open the enclosure. Visible laser radiation when
open and interlocks defeated.
DO NOT STARE INTO THE BEAM.
DANGER Visible laser radiation when open and interlock failed or defeated.
Avoid direct exposure to beam.
CAUTION Do not open the top cover. There are no user serviceable parts inside the Unit;
leave all servicing to qualified service personnel.
CLASS 1
LASER PRODUCT
CAUTION Any changes or modification in construction of this device which are not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
• Make sure the unit is placed at least 8cm apart from other home appliances for the appliances to
get sufficient ventilation.
• This unit shall not be exposed to dripping or splashing and no objects filled with liquids, such as
vases, shall be placed on this unit.
• Switching it off does not disconnect it from the mains (stand-by). To disconnect it from the mains,
you have to unplug it.