Delta 20-950 User Manual

Page 13

TABLE ADJUSTMENTS

RISK OF PERSONAL INJURY. Make sure that nothing is on the table and that the workpiece is clamped

down. Falling objects can cause an injury.

You can tilt the table forward from zero (0) to 45 degrees. To adjust:

1. Loosen the two forward tilt levers (A) Fig. 27.

2. Adjust the table to your desired angle. The scale (B) Fig. 27 is located on the side of the table support.

3. Tighten the levers (A) Fig. 27.

4. A positive stop (C) Fig. 28 is provided to return the table to the zero position. Adjust this stop by turning the screw/

stop (C), located under the table. Tighten the locknut to secure the stop.

You can tilt the table right or left. Positive stops are included for 0, 45 and 90 degrees. To adjust:

1. Loosen the table bolt (E) Fig. 29 approximately 1/4 turn with the supplied 14mm hex wrench.

2. Pull out the spring-loaded detent pin (F).

3. Rotate the table to your desired angle. The tilt scale (G) Fig. 30 is located on the knuckle behind the table. Use this

scale for accuracy. You can allow the detent pin to slide in to the positive stops (0, 45, and 90 degrees), but check
your scale to be sure of the exact angle.

4. Tighten the table bolt.

Fig. 27

Fig. 28

C Located under table

Fig. 30

Fig. 29

T-SLOTS

The drill press table is fitted with two T-slots (L) Fig. 31
for use with various drill press accessories (stop blocks,
fences, or clamps). Use 5/16" T-bolts when attaching
your accessory to the table.

Fig. 31