Hoist Fitness HD-1400 - Manual (Page 16)

CABLE
A
SSEMBL
Y
Step
3
J - 3/8”-16 UNC x 3” Hex Bolt
AB - 3/8” Flat Washer
BB - 3/8” Nylok Nut
CK - 1/2” Flanged Spacer
CL - 4 1/2” Pulley
CM - 11/16” Flanged Spacer
CR - Leg Extension/Curl Cable
DD - Quick Release Cable Lock
DF - 7/16” External Retaining Ring
K - 3/8”-16 UNC x 2 1/2” Hex Bolt
Hardware Descriptions
Page
-
15
HD1400
Assembly
O
WNERS
MANU
AL
CR
NOTE:
BE SURE CABLE RUNS
BETWEEN THE PULLEY AND
THE GUARD SHAFT.
NOTE:
BE SURE CABLE RUNS
BETWEEN THE PULLEY AND
THE GUARD SHAFT.
NOTE:
BE SURE CABLE RUNS
BETWEEN THE PULLEY AND
THE GUARD BOLT.
NOTE:
BE SURE CABLE RUNS
BETWEEN THE PULLEY AND
THE GUARD BOLT.
FINE TUNING
LOOSEN JAM NUT AND THREAD
BOLT IN/OUT TO GIVE THE CABLE
PROPER TENSION. RE-TIGHTEN
JAM NUT.
FINE TUNING
LOOSEN JAM NUT AND THREAD
BOLT IN/OUT TO GIVE THE CABLE
PROPER TENSION. RE-TIGHTEN
JAM NUT.
182 7/8” (4645mm)
WARNING:
CABLE BOLT MUST BE THREADED
A MINIMUM OF 1/2” INTO ITS RECEIVER
WITH JAM NUT TIGHTENED SECURELY TO
ENSURE PROPER CONNECTION.
WARNING:
CABLE BOLT MUST BE THREADED
A MINIMUM OF 1/2” INTO ITS RECEIVER
WITH JAM NUT TIGHTENED SECURELY TO
ENSURE PROPER CONNECTION.