Hoefer PS2A200 User Manual
Page 21
Setting constant wattage output
1
Select “Const Watt”
Place the cursor in the first field of the second line by
pressing the select arrow keys (left and right arrows
under the display). Then press the adjust arrow keys
(pointing up and down) until “
Const Watt” appears in
the field.
As you scroll through the four options, a short beep
indicates each change.
2
Set the wattage value
Place the cursor under the digit in the W digit field that
you wish to change by pressing the select arrow keys.
Select the value of the digit by pressing the adjust arrow
keys. A short beep indicates that the change was regis-
tered. Repeat for each of the three active digits in this
field (1–200 W).
3
When the start/stop key is pressed to start the run, the
cursor will be in the W field to indicate that this value
is being held constant. This value can be edited without
switching to SET mode. To edit other parameters during
a run, press the set/read key.
•
p12
#1 Protocol 1
Const Watt 200 W
Continuous run