Power parameters – Hoefer PS2A200 User Manual
Page 18

Power parameters
There are many possible displays in SET mode, but all
use the format illustrated immediately below. (In contrast,
READ mode, shown at bottom, is always characterized by
a display of all three V, mA, and W values.)
SET mode
Note: The power supply is
in SET mode by default
except when power is being
delivered to a load. Once
the HV output is on (the
start/stop key has been
pressed) SET mode is
selected by pressing the
set/read key. After 5 s of
inactivity, the power supply
switches to the READ mode
automatically.
•
p9
Continuous
Timed Hrs
T/Hold
Timed Vhrs
Const Amp
Const Volt
V&mA
Const Watt
#1 Protocol 1
Const Volt 200 V
Timed Hrs
Step 1 10:00 hrs
Protocol number 1–3
Step number 1–3
Hrs:min or Vhrs
Protocol name 13 characters
Step number 1–3
Continuous
Timed Hrs
T/Hold
Timed Vhrs
100Volts 500mA
50Watts
Step 1 10:00 hrs
0:30 Hrs Elap
Hrs:min or Vhrs Elapsed
Output current
Set parameters
Output voltage
Output watts
READ mode