Establishing the power supply, Insert the supplied power cable – Guntermann & Drunck LwLVision-USB 2.0 User Manual

Page 11

Installation

G&D LwLVision-USB 2.0 · 8

Establishing the data transmission to the user module

Trans. Tx:

Insert the SC plug of a fibre optic cable.

Connect the other end of the cable to the Trans. Rx interface of the user module.

Trans. Rx:

Insert the SC plug of a fibre optic cable.

Connect the other end of the cable to the Trans. Tx interface of the user module..

USB 2.0 Trans. Tx:

Insert the LC plug of a fibre optic cable.

Connect the other end of the cable to the USB 2.0 Trans. Rx interface of the

user module.

USB 2.0 Trans. Rx:

Insert the LC plug of a fibre optic cable.

Connect the other end of the cable to the USB 2.0 Trans. Tx interface of the

user module.

Establishing the power supply

Main Power:

Insert the supplied power cable.

Red. Power:

Use this interface to connect an optional external power pack for a sec-

ond, redundant power supply.

IMPORTANT:

The device uses laser technology complying with laser class 1. Although

class 1 laser beams are considered nonhazardous, avoid direct eye contact.
Do not stare into the beam using optical instruments.

NOTE:

Please remove the protection caps from the Transmission interface and the

cable plugs.

NOTE:

Please remove the protection caps from the USB 2.0 Trans. and the cable

plugs.

Main

Power

RS 232

Red. Power

DVI/VGA Out

DVI/VGA CPU

Line In Line Out

USB 2.0 CPU

Service

Mouse

Keyb.

PS/2

PS/2

USB

Keyb./Mouse CPU

USB 2.0 Trans.

Trans.