Gullco KBM-28 - Manual (Page 17)

13
12
13
14
13
14
12. Re-tighten the nut of the Angle
Alignment Bolt.
13. In order to tilt the main body of the
machine to the desired bevel angle, two
(2) clamping bolts must be loosened,
allowing the machine to pivot around an
axis at the front of the Tilting Base
Frame. Loosen the two (2) bolts, one
(1) on each side of the Tilting Frame
Base.
14. Turn the tilt Hand Wheel, located at the
rear, to tilt the main body of the machine
so that the centre of the rear clamping
bolts (referred to in step 13) line-up with
the appropriate marks engraved on each
side of the Tilting Base Frame.
Note: Hydraulic undercarriage
may not be as shown.