Gullco GK-189-045 - Manual (Page 3)

1
SAFETY INSTRUCTIONS
Although the “KAT II” carriage is manufactured for safe and dependable operation, it is impossible
to anticipate those combinations of circumstances which could result in an accident. An operator of
the “KAT II” carriage is cautioned to always practice “Safety First” during each phase of operation,
set-up and maintenance.
Read and understand the operation manual before operating or performing service of this
equipment. Become familiar with the machines operation, applications and limitations. Keep the
operation manual in a clean area and always at a readily available location.
This equipment is normally used to automate / semi-automate welding or cutting processes. These
processes usually have any combination of the following; bright and hot arcs, flying sparks, fumes,
ultra-violet and infra-red radiated energy, hot work-pieces, compressed gases, etc.. The onus is on
the operator of this equipment to know, understand and follow all the safety precautions associated
with the process being used.
A careless operator invites troubles, and failure to follow safety practices may cause serious injury
or even death. Important safety precautions are given in the following:
Electrical Shock Prevention:
• Do not use the “KAT II” carriage in damp or wet locations.
• Do not expose the “KAT II” carriage to rain.
• Never carry the “KAT II” carriage by the cord or pull the cord to disconnect from the
receptacle.
• Keep the cord from heat, oil and sharp edges.
• Inspect power cords periodically and replace if damaged.
• Inspect the security of cords periodically and repair if loose.
• Disconnect the power cord when not in use.
• Disconnect the power cord positively to prevent electrical shock before repair and service of
the equipment.
Bodily Injury Prevention:
• Do not wear loose clothing, jewelry or loose, long hair which may get caught into automatic
systems or moving parts.
• Keep lifting handle dry, clean and free from oil and grease.
• Do not operate this equipment if ill or drowsy from medication or fatigue.
• Always keep the “KAT II” clean and in good working order.
• Report any unsafe condition for immediate correction.
Important:
Ensure that an adequate and well maintained weld return path is provided with good electrical
contact. Failure to do so may result in the welding current passing through the carriage and
damaging the wiring and electrical components.