Safety precautions, Important – Gullco GP-200 User Manual
Page 4

2
SAFETY PRECAUTIONS
The following cautionary/warning labels are attached to each welding positioner:-
The adjacent label pictorially represents the following:
Warning:-
Do not loosen the tilt clamp lever when there is a load
applied to the table. This may result in an unexpected
radial movement!
The above label pictorially represents the following:
Warning:-
Read the manual before turning the unit on and before performing service. Also, positively
disconnect the unit from all power supplies before servicing!
IMPORTANT
READ THIS BEFORE OPERATING THE WELDING POSITIONER
When used with electric arc welding or cutting equipment, ensure that an adequate and well-
maintained power return path is provided with good electrical contact. Failure to do so may result in
the welding/cutting current passing through the Positioner and damaging the wiring and electrical
components.
Important information regarding safety and operation of the “GSP-1000” motor control used in the
Positioner is contained in a supplemental manual attached at the end of the Technical Manual. It is
equally important to read, understand and apply the information contained within that manual. The
supplemental manual (GD-042) has a title “Technical Information For The Gullco “GSP-1000”
Microprocessor Based Motor Control”, and it’s pages are numbered with a prefix of “T-“.
ALL THE SAFE PRACTICES AND PRECAUTIONS MAY NOT BE GIVEN IN WRITING. SOME
ARE BASED ON COMMON SENSE, BUT OTHERS MAY REQUIRE TECHNICAL
BACKGROUND TO EXPLAIN.