Gullco GP-200 - Manual (Page 10)

8
GP-200-016 12” [305 mm] Diameter mounting table. This round mounting table is used to
facilitate direct mounting of components or fixtures and provides six (6) radial
mounting slots and various three (3) hole pitch circle bolt patterns. The mounting
table is quickly and easily mounted on the positioner spindle flange.
GP-300-002 Same as GP-200-016 except that there is a 2.50” diameter centre hole for the
through bore GP-300 positioner.
WPG-250 Gullco Self-Centering Welding Grippers are quickly and easily mounted on the
positioner spindle flange. They are slim but rugged, weighing only about half of
that of a standard chuck, minimizing reduction in positioner capacity. A single
lever provides smooth, positive, self-centering open/close action.
External clamping range = 0.38" [10mm] to 11.25" [286mm]
Internal clamping range = 4.25" [108mm] to 15" [381mm]
Weight 20 Lbs. [9 Kg.]
KR-1000 CSB A free standing support and cutting torch holder assembly. 1-1/8" [28.6mm]
square rack arms and rack boxes provide 11-1/2" [292.1mm] of vertical
adjustment and 10-1/2" [266.7cm] of horizontal adjustment. Supplied with swivel
mounted, standard rack-type cutting torch holder.
KR-2000 CSB Same as above, except uses 1-1/2" [38.1mm] rack arms and rack boxes and
provides 7-1/2" [190.5mm] of vertical and 6-1/2" [165.1mm] of horizontal
adjustment.
KR-1000 WSB A free standing support and welding gun holder assembly. 1-1/8" [28.6mm]
square rack arms and rack boxes provide 11-1/2" [292.1mm] of vertical
adjustment and 10-1/2" [266.7mm] of horizontal adjustment. Supplied with swivel
mounted, adjustable gun holder assembly.
KR-2000 WSB Same as above, except uses 1-1/2" [38.1mm] rack arms and rack boxes and
provides 7-1/2" [190.5mm] of vertical and 6-1/2" [165.1mm] of horizontal
adjustment.
NOTE: The above cutting torch and welding gun support assemblies can be, and often
are, equipped with one (1) or two (2) Gullco motorized rack arms controlled by a
remote joystick pendant. Ask your local Gullco representative for further details.
ALSO AVAILABLE:
Gullco frequently designs and manufactures custom welding systems, often utilizing the welding
positioner. These systems normally use some, or all of the following; a programmable logic control,
a programmable operator interface (that allows the user to easily adjust any of the timed and
counted preset values etc.), pneumatic or motorized slide/slides, interfacing with welding/cutting
equipment, external safety devices, auxiliary process equipment etc. Your local Gullco
representative would welcome the opportunity to discuss how we may assist in automating your
specific application.