Grip Factory Munich GF-Multi Jib - Manual (Page 6)

GF-Multi Jib Instruction Manual
Page: 5
Mounting the angle adjuster Securing it with a safety pin
9. Connect the turnbuckles to the rigging harness. Depending on the rear length being
used, now connect the 2 rigging rods to the turnbuckles and in turn to the rigging rod
connections on the rear extension securing with the safety pins. Hand tighten the rods
by turning the turnbuckles until the rods are taut.
Connecting the rigging rod to extension arm
10. Connect the respective parallelogram rod to the middle section and the angle adjuster
and secure it with a safety pin at each end.
Tip:
The angle adjuster has an integrated leveller. By turning it, the vertical plate
on the angle adjuster can be set to a perfect right angle. Correct setting of the angle
adjuster enhances the crane’s balance.
Connecting the parallelogram rod