Grip Factory Munich GF-Multi Jib - Manual (Page 5)

GF-Multi Jib Instruction Manual
Page: 4
Tilt brake
Locking screw
Pan brake
Attention : Pinch point – both tilt brakes should be locked during transport and
assembly!
5. Connect the 2 sections of the rigging harness to the middle section of the GF-9 and
lock securely with the 4 locking levers..
Rigging harness assembly
6. Connect the cross bar to stabilize the rigging harness. Ensure that the 2 locking pins
are inserted fully.
7. Depending on the version being assembled, connect the rear section to the middle
section. Slip the connection flanges into each other and secure with the provided
safety pin.
Tip:
To avoid the sections jamming or getting stuck make sure that the sections
are joined parallel. Using a small amount of silicon spray also helps.
Mounting an extension arm Securing the arm with a safety pin
8. Connect the angle adjuster to the end of the respective section and secure it from the
inner side of the angle adjuster with the provided safety pin.