Greenheck Utility Distribution System - Manual (Page 4)

GREENHECK
¨ October 1999
4
UTILITY DISTRIBUTION SYSTEM
Model GUI Installation
B. ISLAND MOUNTED:
1. Read entire manual and study drawings before starting
installation.
2. Check that all electrical and plumbing rough-ins are as
specified and agree with the drawing.
3. The GUI system consists of the following parts:
a. Riser (optional)
b. Raceway
c. Pedestal (optional)
4. Remove all access panels on raceway, riser and
pedestal to reveal internal plumbing, electrical systems,
and internal flanges.
5. Place GUI sections according to the drawing to
determine the proper mounting positions.
6. Once sections are in position, join field joints (if any) by
bolting internal flanges together and applying NSF
approved silicone caulk (GE SCS-1009, or its
equivalent ) over seams. Caulk is not provided.
7. GUI mounting procedures:
a. Drill holes in floor to match the hole pattern of
the riser bolt flanges.
b. Insert fasteners, (supplied by others) through the holes in the riser bolt flanges and secure to the
floor.
c. Seal around teh bottom of the riser with an NSF approved silicone caulk, (GE SCS-1009, or its
equivalent). Caulk not provided.
8. If height of GUI interferes with perimeter of hood at time of installation, proceed as follows:
a. Remove pedestals
b. Slip riser up into hood
c. Reattach pedestals
9. Secure field joint support pedestal(s) to the floor as required, and seal around the bottom with an NSF
approved silicone caulk, (GE SCS-1009, or its equivalent). Caulk not provided.
Island Mounted