Greenheck Utility Distribution System - Manual (Page 3)

GREENHECK
¨ October 1999
3
UTILITY DISTRIBUTION SYSTEM
Model GUW Installation
A. WALL MOUNTED:
1. Read entire manual and study drawings before starting
installation.
2. Check that all electrical and plumbing rough-ins are as
specified and agree with the drawing.
3. The GUW system consists of the following parts:
a. Riser
b. Raceway
c. Pedestal (optional)
4. Remove all access panels on raceway, riser and pedestal
to reveal internal plumbing, electrical systems, and internal
flanges.
5. Place GUW sections according to the drawing to determine
the proper mounting positions.
6. Once sections are in position, join field joints (if any) by
bolting internal flanges together and applying NSF
approved silicone caulk (GE SCS-1009, or its equivalent )
over seams. Caulk is not provided.
7. GUW mounting procedures:
a. Mount stainless steel channel (shipped loose) in proper location on wall.
b. Place unit on channel and insert studs, on the unit, into the holes in the channel.
c. Drill holes through unit as shown on drawing and secure properly to wall.
8. If height of GUW interferes with perimeter of hood at time of installation, proceed as follows:
a. Remove pedestals
b. Slip riser up into hood
c. Reattach pedestals
9. Secure field joint support pedestal(s) to the floor as required, and seal the unit to the wall and floor with
an NSF approved silicone caulk, (GE SCS-1009, or its equivalent). Caulk not provided.
Wall Mounted