Greenheck SP and CSP (477179) - Manual

Installation, Operation and Maintenance Manual
Please read and save these instructions for future reference. Read carefully before attempting to assemble,
install, operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property damage!
1 Ceiling Exhaust and Inline Fans
WARNING!
To reduce the risk of fire, electric shock, or injury,
observe the following:
• Suitable for use with solid state speed controls.
• When cutting or drilling into wall or ceiling, do not
damage electrical wiring or other hidden utilities.
• Acceptable for use over a bathtub or shower
when installed in a GFCI protected branch circuit.
(up through size SP-A390)
• Never place a switch where it can be reached
from a tub or shower.
• Ducted fans must always be vented to the
outdoors.
• These fans are not recommended for cooking
exhaust applications. They are designed primarily
for low temperature, clean air applications only.
The diagram shows the minimum distances these
fans should be placed in relation to cooking
equipment.
• Fan/Light combination is not to be installed in a
ceiling thermally insulated to a value greater than
R40.
CAUTION!
• For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and
vapors.
This product must be properly and reliably
grounded.
Use this fan at the rated voltage and
frequency indicated on the name plate.
Do not allow water to contact electrical parts
such as motors or switches.
Do not switch this product on or off in case
of gas leakage; otherwise, the electric spark
may result in an explosion.
Do not spray or clean this product directly
with water or other liquid; otherwise, a short
circuit or an electrical shock may occur.
For this fan, precautions must be taken to
avoid the back-flow of gases into the room
from the open-flue of gas or other fuel-
burning appliances.
Do not disassemble the unit for
reconstruction.
Make sure that its power switch is set to OFF
before you touch this product; otherwise, an
eletrical shock may occur.
This fan must be installed by a qualified
technician.
Use a device for disconnection from the
supply, having a contact separation of at least
3 mm in double poles switch, which must be
incorparated in the fixed wiring in accordance
with the local electrical wiring rules.
Routine maintenance is required every year.
Ensure that the fan is switched off from the
main supply power source before removing
the guard.
This fan should be installed so that the blades
are more than 2.3 m above the floor.
This appliance is not intended for the use
by persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
127V/60Hz/1-ph
Black wire is “Hot”
White wire is “Neutral”
Green wire is “Ground”
220V/60Hz/1-ph
Black wire is “Hot”
White wire is “Hot”
Green and Yellow wire
is “Neutral/Ground”
®
®
®
Document 477179
Model SP
Model CSP
Ceiling Exhaust and Inline Fans