Greenheck SP-C50 - Manual (Page 2)

5. Replacement installation:
Position housing so that it is
centered in existing opening.
MAKE SURE HOUSING IS
FLUSH WITH FINISHED
CEILING OR WALL. After
making electrical and duct-
work connections (see steps
4, 5 and 6), nail housing in place. Drive nails through the
housing where indicated by arrows.
5 . New installation in an existing ceiling or wall:
SERVICE PARTS
From above ceiling or behind wall,
position housing against stud or joist. Trace outline of housing on
ceiling or wall material. Set housing aside and cut opening. Place
housing in opening such that its BOTTOM EDGE IS FLUSH WITH
FINISHED CEILING OR WALL. 1/2" ceiling or wall material: Bend
tabs outward 90
0 (use a screwdriver if desired) to rest on top of
ceiling or wall material and provide extra stability. Nail in place
using four nails to ensure a solid, quiet installation.
➜
➜
➜
6. Install 3" round duct onto damper/duct connector. If rigid
ductwork is used, its seam should be positioned at top of
damper/duct connector. Tape the joint and extend ducting to a
wall cap or roof cap. Make sure the damper operates freely.
Ceiling or wall can now be finished.
8. Squeeze grille springs together and insert springs into slots in
motor plate. Push grille up against ceiling or wall.
7. Replace the motor plate removed in Step 1. Insert two motor
plate tabs into slots in housing and then pivot motor plate up
until the third tab on plate snaps into matching slot in housing.
Make sure tabs hold motor plate securely in place. Plug in
motor.
Greenheck warrants this equipment to be free
from defects in material and workmanship for a
period of one year from the purchase date.
Any units or parts which prove to be defective
during the warranty period will be repaired or
replaced at our option when returned to the
factory, transportation prepaid.
Greenheck Fan Corporation will not be respon-
sible for any installation or removal costs.
Greenheck Fan Corporation
P.O. Box 410
Schofield, Wisconsin 54476-0410
(715) 359-6171
1
3
2
10
7
8
9
4
6
5
99041161J
IOM SP-C50 6-02
KEY PART
NO. NUMBER DESCRIPTION
1 97011723 Grille Assembly (Includes Key Nos 1 & 2)
2 99140187 Grille Spring (2 Required)
3 99080254 Motor
4 98006791 Motor Plate
5 99110655 Blower Wheel
6 99260428 Nut #6-32 (2 Required)
7 97008632 Damper/Duct Connector
8 99271252 Receptacle
9 98006773 Wiring Cover
10 97008319 Housing Assembly
Always order replacement parts by "PART NUMBER" - not "KEY NO."