Greenheck Jackshafting Kits (474210) User Manual
Jackshaft kits, Field installation instructions, One inch jackshaft kits for 48 in. long jackshafts

Document Number 474210
Jackshaft Kits
FIELD INSTALLATION INSTRUCTIONS
1 in. diameter jackshaft kit - 48 in. long (Part no. 860059)
Item
Description
Part
No.
Qty
1
1 inch jackshaft
734095
1
Hardware Kit (part no. 860058) includes the parts listed below.
2
1 in. diameter jackshaft bracket assy w
nyliner
834292
2
3
Thread stud, 1/4 - 20 x 1/2 in.
415609
4
4
1/4 - 20 spinlock nut
415455
4
5
Blade bracket
653629
1
6
MS 1/4 -20 x 1/2 in. (HWH) TCS ZP
415264
2
7
1 in. hose clamp
451809
2
8
1 in. crankarm assembly
816252
1
9
5/16 in. diameter linkage rod 18 in long
656472
1
10
Ball swivel
451554
2
One Inch Jackshaft Kits For 48 in. Long Jackshafts
Note: Kit includes required parts for single section dampers.
1. Attach jackshaft brackets (item 2) to the frame with 1/4-20
thread studs (item 3) and 1/4-20 spinlock nuts (item 4).
2. Attach the blade bracket (item 5) to the blade with
1/4-20 x 1/2 in. machine screws (item 6).
3. Assemble the hose clamps (item 7), crankarm assemblies
(item 8) onto the jackshaft (item 1) as shown.
4. With the jackshaft positioned between the jackshaft
brackets (item 2) and hose clamps (item 7), close the
blades completely and align the crankarm assembly (item
8) with the blade bracket (item 5). Assemble the linkage
rod (item 9) and ball swivels (item 10) to the blade bracket
(item 5). The linkage rod may need to be cut down as
required depending upon the length required to connect
the ball swivels with the blade brackets.
5. Secure the assembly by sliding the hose clamps (item 7)
up to each jackshaft bracket (item 2) to secure the shaft.
6. On internal mount, the jackshaft must not extend past
the jackshaft brackets. On external mount, the jackshaft
extends past the jackshaft bracket on the actuator side 6
inches (for actuator attachment). Cut down jackshaft as
required.
®