Figure 7 – Greenheck Fabra Hood, Single Section with Filters, throat length less than or equal to 72 inches (471322) User Manual

Page 4

Step 9

Step 10

Fabra Hood Form F Assembly Instructions, Rev. 2, October 2012

Figure 7 Fabra hood Form F 471322

Assemble HOOD PANELS to HOOD RAIL ASSEMBLY.
The HOOD END ASSEMBLY with the MALE RIB is to
be installed first. (See Figure 7, DETAIL "E") Place the
remaining HOOD PANELS in place, interlocking panels
as you go. (See DETAIL "E") Secure each HOOD PANEL
to the HOOD RAIL ASSEMBLY as it is put in place
using four (4) No. 12 X

⁄

inch sheet metal screws with

sealing washers per HOOD PANEL. The HOOD END
ASSEMBLY with the FEMALE RIB is to be installed last.

NOTE: Hoods over 9 feet wide are supplied with
special HOOD CLIPS. (See DETAIL "F'') HOOD
PANELS have predrilled holes for HOOD CLIP
installation. Install CLIPS as HOOD PANELS are being
put in place, using one (1) No. 12 X

⁄

inch sheet metal

screw with sealing washer per HOOD CLIP. To install
CLIPS in the last panel, remove the end FILTERS to
provide access to the underside of the hood. The
FILTERS can be easily replaced after the hood is
completely assembled.

Figure 7

Step 10 Fabra hood Form F 471322

Tighten all pivot bracket fasteners.

NOTE: There may be extra fasteners.

Phone: (715) 359-6171 • Fax: (715) 355-2399 • E-mail: [email protected] • Website: www.greenheck.com